Do you know how to use dynamic roller skates? Next, our skateboard wheel manufacturer will briefly talk to you about some specific methods, hoping to help you!
First, press the shoe on the ankle “press plate”, pull out the ankle band from under the press plate, and open the “fixing belt” on the foot. Put on socks and roller skates, and then fix the ankles and insteps in sequence. To fix the ankle, place the tongue on the inner side of the shoe bladder. When holding the ankle firmly, first open the buckle and stretch the cassette under the pressure plate, flatten the tongue, press the buckle back and press it tightly. Finally, tighten the fixing belt on the upper and stick it well.
Adjust the size of roller skates: loosen the fixing devices at the ankle and instep, and then turn the “conditioner” counterclockwise 180 degrees, and then the “upper shoe body” can be pulled out or retracted to adjust the size of the shoe to a suitable gear Then screw the conditioner back to fix it. Do not put the tongue between the bladder and the shell.
Check the tightness of the parts after running-in: New shoes usually have loose parts. You can tighten them properly and check them again after wearing for a period of time. The wheels are easy to fall when wetted: Most of the roller skate wheels are made of pu raw materials. It is very slippery on the ground, both front and rear, and it is very easy to fall; the bearing is prone to rust in water.
The bearing material of roller skates has high hardness and carbon content. Water is easy to rust, so do not let water enter the bearing. Once the water is rusty and there are creaks, please clean it according to the “Cleaning Methods for Roller Bearings” in the “Maintenance Methods” below. Children learning roller skating, must remember to wear socks and then roller skates, because a very small amount of sweat on the feet will make it difficult for the feet to reach into the shoes, otherwise if they are barefoot, they will not be easy to take off the shoes after a period of sweating. Up.